- Out-of-Stock
The specification for this castor is simple: relieve the hinge of the swinging door as much as possible!
We slide the castor under the door, screw the plate onto the door using M4 countersunk screws, and then adjust the desired travel within a range of 10 mm. Once the travel is reached, we tighten the two nuts on the M10 threaded rod, and then tighten the four nuts on the plate to lock the height.
In summary, we can raise the end of the door by 1 cm, which is more than enough in most cases.
Very practical model! The wheel is made of non-staining and noise-reducing polyurethane, mounted on high-performance ball bearings.
You might also like